Boxing ring

From Wikipedia, the free encyclopedia

This is an old revision of this page, as edited by Joefromrandb (talk | contribs) at 22:25, 28 December 2017 (→‎See also: already linked in the article). The present address (URL) is a permanent link to this revision, which may differ significantly from the current revision.

An AIBA full-sized competition ring

A boxing ring is the space in which a boxing match occurs. A modern ring, which is set on a raised platform, is square with a post at each corner to which four parallel rows of ropes are attached with a turnbuckle. Unlike its cousin the wrestling ring, the ropes in a boxing ring are generally connected together between the posts.

Construction

As there are a number of professional boxing organizations, the standards of construction vary. A standard ring is between 16 and 20 feet (4.9 and 6.1 m) to a side between the ropes with another 2 feet (0.61 m) outside. The platform of the ring is generally 3 to 4 feet (0.91 to 1.22 m) from the ground. The ring itself has around 1 inch (25 mm) of padding covered by stretched canvas. The ropes are around 1 inch (25 mm) in diameter and at heights of 18, 30, 42, and 54 inches (.46, .76, 1.07, and 1.37 m) above the mat, held up on posts rising around 5 feet (1.5 m) above the mat,

Construction of the ring environment extends to maximization of lighting in the ring, minimization of heat of the lighting, and a complete as possible cut-off of illumination at the ringside.[1]

Terminology

The name "ring" is a relic from when contests were fought in a roughly drawn circle on the ground. The name ring continued with the London Prize Ring rules in 1743, which specified a small circle in the centre of the fight area where the boxers met at the start of each round. The first square ring was introduced by the Pugilistic Society in 1838. That ring was specified as 24 feet (7.3 m) square and bound by two ropes. For these and other reasons, the boxing ring is commonly referred to as the "squared circle". The term "ringside seat" dates as far back as the 1860's.[2]

See also

References

  • "Equipment–Ring". AIBA. Retrieved January 10, 2013.
  1. ^ Transactions -Illuminating Engineering Society (London, England) - 1952 Volumes 17-18 - Page 178 "There cannot be very many gymnasia where there is not sufficient general lighting to allow practice bouts to take place under perfectly satisfactory conditions. For a big fight, however, the amount of light can hardly be too great, and the heat that goes with these high values of illumination is a discomfort with which the boxers must contend as best they can. The method usually used to confine the light to the ring and give a cut-off as complete as possible at the ringside is illustrated in Fig."
  2. ^ Christine Ammer Southpaws & Sunday Punches and Other Sporting Expressions - 1993 1618422618 "The term "ringside seat" dates as far back as the 1860's. During the course of the century, however, it began to be used quite generally for a good view (literal or figurative) of any event, not necessarily an athletic one."